Radar and RF sensors
The design of the FMCW radar and RF sensors used in ground‑to‑air and air‑to‑ground sensing is the common technology base of all the company’s work.
The performance of an FMCW radar sensor is determined by the combined design of its antenna, RF front end, chirp waveform and signal processing chain. The balance between range, velocity and angular resolution, power consumption and size is struck afresh for each application.
Sentirox treats the sensor as a whole, with a single team responsible for it from board level to algorithm. Design decisions are verified by measurement and recorded.

Focus areas
FMCW waveform design
Setting the chirp slope, bandwidth and frame structure of a frequency-modulated continuous-wave (FMCW) radar to the application’s range, velocity and resolution requirements, and examining range-velocity ambiguity and clutter behaviour by simulation at the design stage. Pulsed waveforms are considered where the application calls for them.
Antenna and RF front end
Design of printed antenna arrays, feed networks and the RF front end, with noise figure, linearity and transmit-receive isolation optimised on the basis of measurement. Antenna patterns are measured on in-house set-ups and, where needed, at external antenna test facilities, and compared with simulation.
Signal processing
Designing range and Doppler FFT processing, constant false alarm rate (CFAR) detection, angle estimation and track formation algorithms together with the processor or FPGA architecture they will run on. Algorithms are tested against recorded field data.
Calibration
Correction of channel gain and phase differences, range zero offset, temperature drift, and radome and antenna mounting effects, with post-production calibration performed on repeatable test set-ups.
Environmental robustness
Mechanical and thermal design of the sensor electronics for vibration, shock, temperature, humidity and pressure conditions, and joint assessment of the radome material’s RF transparency and durability.
Size, weight and power
Designs that combine the antenna, RF front end and processing unit on a single board, with the balance between range, power consumption and size set by link budget calculations.
Test, verification and qualification
FMCW radar sensors are measured in the laboratory for receiver sensitivity, transmit power, phase noise and antenna pattern; the results are compared with design simulations.
Range and velocity accuracy are verified with reference targets and moving-target set-ups. Data is recorded in outdoor trials under a range of target and clutter conditions.
Environmental and electromagnetic compatibility tests are planned in accordance with standards such as MIL-STD-810 and MIL-STD-461, according to the environment in which the sensor will be used, and carried out at accredited test laboratories. The results are added to the configuration records.
Other business areas
Contact
Sentirox can be reached by email for corporate matters, collaboration enquiries and job applications.


