Sensor electronics and embedded software

Sentirox regards a sensor’s electronics and the embedded software that runs on them as the components that determine its reliability in the field.

A sensor’s behaviour in the field is governed not only by its algorithm but by the board’s power integrity, timing stability, interface reliability and the software’s response to fault conditions. Electronics and embedded software are therefore developed by the same team and under the same verification regime as the algorithms.

In sensor electronics, Sentirox works on small, low-power board designs suited to series production for FMCW radar sensors, and on the real-time embedded software that runs on them. Testability in series production is designed in from the start.

A signal generator and an oscilloscope on a laboratory bench

Focus areas

  • Board design

    Multilayer printed circuit design housing the RF, analogue and digital sections on one board, with layout driven by impedance control, power integrity and electromagnetic compatibility. Component selection takes continuity of supply and temperature grade into account.

  • Embedded software

    Real-time software on the sensor processor: measurement cycle, signal processing chain, fault handling and safe-state functions. Software is developed to coding standards and checked by static analysis; releases are held under configuration management.

  • Data interfaces

    Output of sensor data over interfaces such as CAN, UART/RS-422, SPI and Ethernet using a defined protocol, with interface control documents (ICDs) prepared jointly with the user and timing requirements verified.

  • Built-in test and health monitoring

    Self-test at power-up (PBIT), continuously during operation (CBIT) and on request (IBIT); monitoring temperature, supply and RF path health and reporting status over the interface.

  • Power management

    Low-power design for sensors running on battery or platform power: sleep and wake cycles, supply sequencing and protection against voltage transients, with platform power-quality standards such as MIL-STD-704 and MIL-STD-1275 taken into account.

  • Production and test

    Design for series production, test points and production-line test fixtures, with each board’s calibration and test record tracked by serial number.

Test, verification and qualification

Boards are measured on the bench for power, timing and interface behaviour; embedded software is verified by unit testing and testing on the target hardware.

Every embedded software release is regression-tested on the target hardware and recorded under configuration management.

Environmental and electromagnetic compatibility tests are planned for the environment in which the sensor will be used; the test reports are kept with the board’s delivery file.

Contact

Sentirox can be reached by email for corporate matters, collaboration enquiries and job applications.